March 16, 2023 Sales: (800) 428-4442 | Technical (800) 428-4511
TIS 1205 2
HolcimElevate.com
Do not use as a batten strip.
Where field cutting is necessary, remove any burrs from bar ends.
Clean up shavings, etc. that may occur from field cutting.
Termination bars must be installed directly to the wall surface, not to existing sheet metal, flashings, etc.
Install termination bar on hard, smooth surfaces only. Do not install on substrates where seal is lost at
mortar joints, etc.
Do not install termination bar to wood or other porous surfaces.
®
n
Post-Consumer Recycled Content: 0%
Post Industrial Recycled Content: 67%
Manufacturing Location: Cleveland, OH
NOTE: LEED® is a registered trademark of the U.S. Green Building Council
Typical Properties
Material 6063-T5, or T6 Aluminum
Length 10' (3.1 m)
Height
1.08ޏ (27.4 mm)
Thickness
0.087ޏ (2.2 mm)
Holes
Slotted, 0.28ޏ x 0.39ޏ (7.1 x 9.9 mm) 30 at 3.9ޏ (99.8 mm) o.c.
Please contact Holcim Technical Services at 800-428-4511 for further information.
This sheet is meant to highlight Elevate products and specifications and is subject to change without notice. Holcim takes
responsibility for furnishing quality materials that meet published Elevate product specifications or other technical
documents, subject to normal manufacturing tolerances. Neither Holcim nor its representatives practice architecture.
Holcim offers no opinion on and expressly refuses any responsibility for the soundness of any structure. Holcim accepts no
liability for structural failure or resultant damages. Consult a competent structural engineer prior to installation if the
structural soundness or structural ability to properly support a planned installation is in question. No Holcim representative
is authorized to vary this disclaimer.